OPS Outlet Power Strips

Why worry about finding enough power sources when CMP can build them right in? Our outlet power strips allow between three (3) and twelve (12) pieces of equipment per strip to be plugged in.

Each power strip has three (3) 12 gage wires (third wire copper ground) and are rated for 125 volts, 15 amp single phase.
NOTE: CMP can also wire your outlet strip to our power panels, or to a cord assembly (please specify cord length and type of plug).

ERP Electric Rack Panels

CMP offers three rack mountable panels to help you complete your electrical circuitry. Standard power source for all is 115 volt, 50-60 HZ.
ERP-CB -- A 15 amp circuit breaker that provides protection for all equipment in the rack.
ERP-DR -- Allows you to add a duplex outlet for use when you want to use your rack’s power source with non-mounted equipment. 15 amp capacity.
ERP-TLR -- Lets you bring electrical power into the enclosures through a twist-lock receptacle that may be wired to a power strip or directly to equipment. 15 amp capacity.

ECA Electrical Cord Assembly

CMP’s 72", 120" and 240" cord assemblies make it easy to bring power into an enclosure. Three (3) wire 14 gage cords have a standard 3-prong grounded plug at one end and a female twist lock receptacle at the other end. Provides 115 volt, 15 amp power.

NOTE: Ask about different voltages, higher amp ratings or other configurations.

CBB Copper Bus Bar

When you need to ground equipment independent of the enclosure frame, CMP’s copper bus bar is the answer. Mounts vertically with insulating hardware to provide electrical isolation, easy use.

RFC Runway For Cables

CMP’s all-plastic cable runways allow wiring to be neatly bundled and run vertically within your enclosure. Branching to mounted equipment is greatly simplified and space is used more efficiently.

RCA Retractable Cable Arm

Protect your cables from signal loss due to stretching, crimping and tangling with CMP’s retractable cable arm. Allows heavy cabling harnesses which are attached to a sliding chassis to be pulled in and out of the enclosure without risk to the cables. Manufactured from 12 gage cold rolled steel for durability, the RCA is zinc plated with a dichromate finish to resist corrosion.

Catalog No. RCA-30